Відео

Top break bulb #

For my 2007 its a ten hour job to take the whole dash apart and all the components to access it. I saw a video years ago and. Cut the access hole in the bottom out.

Thank youu

You sound just like Jim the car guy 😅

The slide pins on my 2000 are identical in the front. They both have rubber sleeves on the ends of the pins. On the rear they are different

Very helpful. Thank you!

you do not have to take the tank all the way out to change the pump! it takes me 14 min to change a pump on a mustang 2001. but for the life of me i can not figure out way my mustang does not start on its own. if i use starter fluid it runs fine with no problem.

I come back to this video about 2-3x a year lmao

Does the parking brake need to be engaged when I loosen it or?

No, my steering knuckle isn’t coming off the bottom control arm at all. Not sure why yours just came off?

Great information. Clear step by step instructions. Thank you!

After replacing my fuel pump, it took 4 hours to re-install the tank (I did it by myself using jack stands and 2 jacks) and all went well except the fuel gauge quit working after a few days when I gassed up again. I had to repair the wire to the float assembly before re-installing everything but I might not have done as good a job as I thought. Can the fuel hat and pump assembly be removed without completely removing the tank (can it be dropped just enough to remove the hat bolts and pull out the assembly)? I want to avoid taking the tank completely off if possible.

How do you turn up brightness on screen

GREAT teaching. Thanks, Boss. Grateful.

Thanks to you I knew how to do it, thank you very much, Greetings from Chile.

👍👀👍

Hi what type of filter for honda hrv for cabin and air filter?

Those wire brok caz they make it lit to short

Its easy to put that wire and check it

I got to replace mine. Thanks for the video brother!

Thanks 🙏

Excellent video. Perfect narration. Clear camera work. Very thorough and understandable. I appreciate your recap at the end. This will make my brake pad job much easier. Thanks!!!

Thanks for the video brother, i come here every 6 months per oil change

😮😮😮😮

QUESTION: At 3:59 to 4 Minutes, and 1 second (into the video), when pulling the Rotor, SOMETHING POPPED. the caliper lies on that. in the video - towards the end, re-assemblying, i didn't see how you put that one back? any help? SERIOUSLY GREAT, EDUCATIVE video. adding just the last part of putting everything back together SCORES a 10/10.

Thank you so much for taking the time to film this. Not easy. Enormously helpful.

a very GOOD teacher. step by step instructions. hey Boss, you're the Best. i appreciate you.

Appreciate the video brother.

What are the symptoms to this going bad?

Dude way wrong on this

Muchas gracias señor!!

Thank you. Stuff like this saves a ridiculous amount of money nowadays

Didn't really need to replace it, you could have just cleaned the carbon out...🤦‍♂

I made the mistake of removing the parking brake cable from the lever that attaches to the brake shoe. I can’t get the spring back enough to get the lever back on. Any help??

Are you just resetting it or turning it off? Will service engine soon light come back on in the future if there is a real problem that needs to be addressed?plz lmk or if anyone randomly reading this knows lmk ty

Thank you!! I followed your instructions and got the job done.

Clear that phlegm

Do you have to put gasket sealant on it

Great Video!

Do you need to take off the door panel on a 2013 santa fe sport

Credit to the Mazda design engineers who made it so simple and straightforward to change a bulb, easily accomplished by removing the front of the car

What do you call that tool that pushes both pistons in at the same time? I would like to get that tool.

What type of scanner can I use to determine which door is open? I checked the driver's door but everything is ok and I don't want to check them one by one

Thanks! Straightforward. Easy to understand. 👍

Mine doesnt have power in the pun that goes to the pump could it be the ccrm module ???

There is no screw there on a 2001.

Great video, it really helps a lot

Helpful, what repair kit would I ask for or search for in order to fix this? Plz n ty

these old cars have it easy. the new ones are a nightmare. the little temp control boxes have plastic gears inside them, and they are hell to get to depending on the car. i miss the simplicity of older cars.

I did this and saw that my car does not have a starter motor, what should I do 😭